Kugoo Kirin S1 controller / motherboard.
This is the motherboard also known as a controller for the Kugoo Kirin S1, Also fits some Aovo, please check photos.
Model number: ESA2.3-CE
Maximum current: 15A
Rated voltage: 36VDC
Low voltage protection: 31V – 0.5V
How to fit kugoo Kirin S1 controller
Fitting is relatively simple and shouldn’t take any longer than 15 mins
- Remove the screws holding the base of the scooter and then remove the plate
- 2 screws hold the motherboard in to the base, so remove them.
- 1 cable at a time remove from the old motherboard and connect to the new one. then screw the motherboard back in place.
- Turn on and test the scooter works
- Use a good bathroom sealant and go around the edges of the base plate
- Screw the baseplate back in place and remove any excess sealant with a paper towel.
Kugoo Kirin S1 controller shipping
Our free shipping is with Royal mail 48 and is a 2-3 working day service
If you need it faster please opt in for Royal mail 24 at checkout
International across the EU is a 3-5 day service with Tracking
You can use this link for the tracking