Scooter LED kit

Description

Scooter LED kit

Our Scooter LED kit is designed to fit on the side of your scooter.

Not only does it add a bit of style to your ride but it will help other road users see you at night time. The LED kit is RGB which means you can choose any colour you like. Choose from different patterns, changing colours, set colours and you can set light changing patterns if required. As these are USB you don’t even need to fit them to the scooter if you change your mind.

The kit contains 2x 50cm RGB LED strips with sticky back. Encased in waterproof silicone.

An extra roll of M3 double sided tape.

USB controller cable – which the strips are plugged into.

Battery case for 3x AA batteries (not included) with USB output.

Battery case water resistant bag.

How to fit the Scooter LED kit.

To fit should take no longer than 10 minutes.
Firstly and most importantly clean your scooter with soapy water and a sponge and then dry.

Apply the M3 tape to the back of the LED bars and leave for two minutes to set.

Install the battery case and bag to an appropriate part of the scooter.

Stick the LED strips to the scooter making sure no ends protrude. You can cut the LED strips down at any of the points where you can see 4 copper strips.

Connect to the case.